Questions, banter and general discussion.
597 posts
First ride on the new one was the 27th December.
fordie77@hotmail.com wrote:
Sun Jan 06, 2019 8:11 pm
First ride on the new one was the 27th December.
Done; you will be assigned a category after your next race.
Thanks
Hi. I previously raced with a TacX Flow which overestimated my power wattage. I have since started using PowerTap P1 pedals on Dec 25 (Christmas) and need to be downgraded to a D from a C as my real power is much less. Please remove all race results older than December 25, 2018. Thank you.
Deon Louw wrote:
Mon Jan 07, 2019 4:46 pm
Hi. I previously raced with a TacX Flow which overestimated my power wattage. I have since started using PowerTap P1 pedals on Dec 25 (Christmas) and need to be downgraded to a D from a C as my real power is much less. Please remove all race results older than December 25, 2018. Thank you.
We don't actually downgrade you in that sense. We filter out results on your old set up and your category will get recalculated from races on your new set up.

Confirm it was 25/12/18 when you started using the P1 as there is not a significant difference.
Understood.

Yes, I started using my Powertap P1 pedals on 12/25. Anything before that was power estimated by TacX Flow which was overestimated.

Thanks
Deon
Deon Louw wrote:
Mon Jan 07, 2019 4:58 pm
Understood.

Yes, I started using my Powertap P1 pedals on 12/25. Anything before that was power estimated by TacX Flow which was overestimated.

Thanks
Deon
I've done that.

You've been classified as Cat D but only because of the race on 29/12 being DQ'd :-)
On 1/6/19, my trainer resistance was not set correctly, so please mark it as ERROR. Thanks, Art
artemuss wrote:
Wed Jan 09, 2019 5:14 pm
On 1/6/19, my trainer resistance was not set correctly, so please mark it as ERROR. Thanks, Art
Done thank you.
Hi!

It seems that my Trainer has a defect. Now and than it doesn‘t open up the break and resistance is to high in the flat or downhill. Then again it seem that resistance is too low. Then again everything works ok, but yesterday it „throws in“ 2000W values while sprinting. I am definately not capable of pushing 2kW :D As i made 4th position in the Winter Afternoon Series Race regarding to this „error“, i would like to ask if it is possible to delete this position (set to non-competitive or so), so that i do not get points für this race or set the Race to ERROR or whatever. I definitely do not earn this points.

Thank you Spongee